Single Point Vehicle Crossing Detector with Output Relay
SCYLLA-2 vehicle crossing detector can be used in different civil and military applications for vehicle traffic detection and area surveillance. It is buried into the ground near the area of interest and designed to detect and measure traffic presence, volume and occupancy on the road or at an entrance to an area or building, and allows to take the necessary action.
The detector does not react to nearby humans or animals.
SCYLLA-2 has a relay, FET or current loop output that can be used to trigger a pre-determined action to approaching or departing vehicles, such as set off a light or sound signal, open or close gates or doors, switch traffic and street lights on and off, etc.
If equipped with an additional module, SCYLLA-2 vehicle detector can send SMS notifications to up to 4 different users, alerting them of the location where a sensor was activated.
Features and Benefits
Rod type sensor
Counts crossing vehicles
Output relay, FET or current loop to trigger an action upon a crossing vehicle
Optional module for SMS for up to 4 people
Does not react to nearby humans or animals
Detected vehicle weight
Detected vehicle minimum speed
NC and NO contacts (SPDT)
2 A, 30 VDC; 0.4 A, 125 VAC
Max. switched voltage 250 VAC, 220 VDC
Max. switched current 3 A and power 50 VA
2 pcs. of Open Drain FETs, independently programmable, 24 VDC, 1.6 A
Based on supply current change
Needs current monitoring unit at the cable receiver
3.6 V Li-battery LiSOCl2 type LS14500 (2250 mAh) AA
3 - 24 VDC, 100 mA, separately or from Electronic Access Control System
Continuous operating time
With 3.6 V Li-battery at idle up to 4 years
-40 to +60
Ø2.2 x 15